A Computational Model for Velocity Separation in Shallow Sea

Based on the hydrodynamical feature and the theoretical velocity profiles of tidal flow and vvind-induced flow in shal-low sea, a computational model is established for the first time, which can separate observed velocity into tidal velocity and wind-induced velocity by use of the least square method. With the model, not only the surface velocities of tidal flow and vvind-induced flow are obtained, but also the bed roughness height is determined and the wind velocity above the wa-ter surface is estimated. For verification of the model, the observed velocity in the Yellow River Estuary and the laborato-ry test is separated, then it is applied to the Yangtze River Estuary. All the results are satisfactory. The research results show that the model is simple in method, feasible in process and reasonable in result. The model is a valid approach to analysis and computation of field dala, and can be applied to separate the observed velocity in shallow sea; at the same time, reasonable boundary conditions of th     

A Nonlinear Model of Surf Beat

A nonlinear short-wave-averaged (surf beat) model is presented. The model is based on that of Roelvink (1993), but the numerical techniques used in the solution are based on the so-called weighted-averaged flux (WAF) method (eg Watson et al., 1992), with time-operator splitting used for the treatment of some of the source terms. This method allows a small number of computational points to be used, and is particularly efficient in modelling breaking long waves. The short-wave (or primary-wave) energy equation is solved using a more traditional Lax-Wendroff technique. Results of validation indicate that the model performs satisfactorily in most respects.     

Wave Loads and Protective Techniques of An On-Shore Wave Power Device

In this paper, the extreme wave loads on an on-shore wave power device are investigated. First, boundary element method is applied to solve the three dimensional potential problem based on the small amplitude wave assumption. Then the motion of the Oscillating Water Column (OWC) inside the device and its laods on the device are calculated in time domain. Several protective techniques often applied are simulated by changing the constraint of the upper end of the chamber of the device. Numerical results are used to judge the effectiveness of these techniques. The investigation shows that damping can not effectively restrain the motion of OWC when the period of incident wave is long, which may cause dangerous loads on the structure. The shut chamber can effectively restrain the motion of OWC, but alternatively cause high pressure in the chamber. A Contracting opening with a Taper (CT) can exhaust a great amount of kinetic energy of OWC, and significantly decrease the loads. It is a promising protective tec     

Effect of Berm Width and Elevation on Irregular Wave Run-Up

This paper discusses the effect of berm width and elevation of composite slope on irregular wave run-up. Based on the data obtained from model tests, the formula and distribution of irregular wave run-up on composite slope are derived. The changing of wind speed, width and elevation of the berm are considered comprehensively. The wave run-up with various exceedance probability can be es-timated utilizing the distribution curves of irregular wave run-up.     

Numerical Analysis of Wave Forces on Arbitrarily Shaped Multi-Pillars Over Varying Topography

The modified hybrid element method (MHEM) is utilized to predict and analyze wave forces on arbitrarily shaped multiple bodies. This method can be applied to waves of all water depths, i. e. shallow, intermediate, and deep waters, on slowly varying seabed. The MHEM employs the ICCG method to save CPU and storage, thus the computation of wave forces for large multi-body systems can be carried out on microcomputers. Numerical results of the present method are compared with experimental data and other solutions. It is shown that the MHEM provides more accurate solutions of the wave forces than other numerical methods do. Therefore, the methodology presented herein can be used in the design of coastal and ocean structures.     

分层流体中内孤立波在潜浮式竖直薄板上透射和反射

采用边缘层理论研究了两层流体系统中内孤立波在潜浮式竖直薄板上的透射和反射问题,提出了非线性演化方程的“初值”条件,分析了内孤立波与薄板非线性相互作用的效应。研究表明:流体层的密度比以及薄板伸入上下层的深度对于反射和透射波结构具有显著的影响,薄板伸入下层越深、密度差越小,则薄板阻碍孤立波透射的效率越高;透射波通常演化为单峰孤立波和迅速衰减的尾波,反射波演化为缓慢衰减的尾波列;对于具有小密度差的跃层结构,内孤立波在潜浮式竖直薄板上的透射及其演化近乎是无障碍的。     

大黄鱼病原弧菌拮抗放线菌的筛选与人工诱变

从厦门集美海滩底泥分离得到38株放线菌，用琼脂块法测定它们对大黄鱼病原弧菌-溶藻弧菌和副溶血弧菌的拮抗效果，选择两株拮抗效果较好的放线菌进行诱变，测定诱变后各菌株的抗菌效果，并选择抗菌效果较好的菌株进行第二次诱变，如此反复诱变3次，共得到97株放线菌，结果表明；38株放线菌中的22株对两株病原菌有一定的拮抗作用；用紫外线照射可以获得少量对两株病原菌拮抗作用加强的菌株。     

Wave-Current Forces on Small Square Cylinders (Part I)

-Based on the extended Morison Equation and model tests, the in-line forces on small square cylinders caused by waves (regular and irregular) and currents are analyzed in detail in this paper. The hydrodynamic coefficient CD and Cu related to KC number and the effect of direction of wave incidence are also given, which can be used in engineering practice.     

Research on Characteristics of Density Current Under the Action of Waves

In this paper,the characteristics of density current under the action of waves are describedwith the help of flume experiment and theoretical analysis.The study shows that turbid water under the ac-tion of the waves can present three types of motion,i.e.significant stratification,fragile stratification andstrong mixing.The motion of turbid water presents significant stratification when(H/D)/△ρ/ρ~(1/2)≤4.5,generally this state is known as density current.The formulas of motionvelocity,thickness,and discharge of density current moving on horizontal bottom are derived by use of ba-sic equations such as momemtum equation,equation of energy conservation and continuity equation offluid.The time-average velocity and the thickness of density current under the action of waves have a rela-tionship with such parameters as relative density(△ρ/ρ),wave height(H),and water depth(D).Whenthese parameters are determined,the time-average thickness and motion velocity of density current are al-so determined.The relat     

Model Test of Sand Restraining Force on Pipeline

This paper describes the model tests for determining the axial friction and the lateral resistance of sand to pipeline by using fine sand and prototype pipeline, and the calculation method based on limit analysis theory is verified. The effect of cyclic loading is considered in the test.